Skip to content

Connect SMPTE (LTC)

To synchronize the console with an SMPTE timecode source, connect an SMPTE source to the console.

Important

Information:
The supported time formats are:
- 24 fps (frames per second)
- 25 fps
- 30 fps
If you send 29.97 or 30 drop frame, it will be interpreted as 30 fps.

Important

Information:
The signal strength should be a minimum of 200 millivolts.
Pin 1: Ground
Pin 2: - (minus)
Pin 3: + (plus)

  • Connect the SMPTE source to the LTC IN connector on the rear panel.

The SMPTE source is connected to the LTC IN connector.

grandMA2 full-size LTC IN connector

Source: key_fs_connect_smpte_ltc.html (grandMA2 manual v3.9)